(1) visual programming interface, easy to use;

(2) adaptive variety of remote control, automatic entry keys;

(3) Pulse width measurement accuracy as compared to 1% accuracy;

(4) the intensity of digital detection and judgment, fully simulate the distance test;

(5) dynamic and static current test, microamp, milliamp-speed automatic switching;

(6) 0.5V ~ 4.5V or 1.2V-12V range can be selected, power supply voltage can be digitally programmed, error <± 0.05V;

(7) can be easily achieved high low voltage and polarity programmable transformation;

(8) 0 voltage (positive and negative tiny resistors shorted) Programmable discharge;

(9) Easy adjustment fixture, remote controller adapted to different shape, quick and easy to set up different remote detection program;

(10) Optional remote visual inspection function, check the appearance of poor printing, offset printing, misting, buttons installed wrong, the wrong color, etc.;

(11) Click header precise, easily and quickly coordinate positioning keys easily increase or decrease, move, change the test keys and functions;

(12) using the ping-pong mode, so separate sets of test fixture, while taking the discharge side of the detection, simultaneous detection of up to four remote control;

(13) Tested 1,000 units per hour, the fastest remote control (approximately 50 keys), almost matching the remote control does not function speeds close vision inspection, a multiply step process is completed, greatly improving efficiency and save on labor costs,at least 4-6 people can be saved in labor;

(14) Test results displayed automatically saved, bad key, bad machine at a glance;

1. Test Functions:

(1) to test the remote control infrared signal strength, infrared codes shaped, quiescent current, dynamic current, carrier error,emission frequency and frequency diaviation, etc.;

(2) If the appearance of one of the selected detection function, you can check the remote appearance quality: poor printing, offset printing, misting, buttons installed wrong, the wrong color, etc.;

2. Technical Specifications:

(1) Programmable output voltage supply ;

(2) using the method of learning waveform waveform comparison, test the correctness of the infrared transmitter encoding;

(3) provide static current test, range of 1-200uA, the accuracy ± 1uA;

(4) provide dynamic current test, range is 2-150mA,, accuracy ± 1mA;

(5) The carrier error detection accuracy of 1%;

(6) fully simulate infrared emission from the test;

(7) Remotor's Apperance inspection of the technical References are as follows:

1) Minimum detectable defect diameter is 0.2mm;

2) use of program-controlled long-life LED light source and a unique optical design of the structure, the light source life of three years or more, can be adapted to surface drawing, uneven, reflective, curved buttons and other types of remote control clear imaging;

3) Four remote control image acquisition and processing time of less than 4 seconds, the equivalent of 1 second appearance of detecting remote controls;

Used machine design, no special installation requirements, the external input is as follows:

(1) Voltage Input AC 220V ± 10V，Power 350w,10A Power Plug;

(2) Gas source input 4-6Bar,10 Minute Pipe( eq 1.25inch);